Config Diffserv Policy Expedite Kbps - NETGEAR GSM7324 Reference Manual

L3 managed switch 7000 series, software v1.0
Hide thumbs Also See for GSM7324:
Table of Contents

Advertisement

Format
Restrictions
Policy Type
Incompatibilities

config diffserv policy expedite kbps

This command identifies the maximum guaranteed amount of bandwidth to be reserved for the
specified class instance within the named policy using an absolute rate notation. The
and
<policyname>
<classname>
respectively. The committed information rate is specified in kilobits-per-second (Kbps) and is an
integer from 1 to 4294967295. The optional committed burst size is specified in kilobytes (KB) as
an integer from 1 to 128, with a default of 4.
Note: The actual bandwidth allocation does not occur until the policy is attached to an interface in
a particular direction.
Note: The expedite kbps and percent commands are alternative ways to specify the same expedite
policy attribute.
Format
Restrictions
Policy Type
Incompatibilities
CLI Commands: Differentiated Services
7000 Series L3 Managed Switch Reference Manual for Software v1.0
config diffserv policy bandwidth percent <policyname>
<classname> <1-100>
The sum of the committed information rate values for all band-
width and expedite commands defined within a policy must not
exceed the available link bandwidth of the interface to which that
policy is assigned. Violation of this requirement shall prevent
successful attachment of a policy to the interface, or shall cause
this command to fail if the policy is already in service on one or
more interfaces.
Out
Expedite (all forms)
are the names of an existing DiffServ policy and class,
config diffserv policy expedite kbps <policyname>
<classname> <1-4294967295> [1-128]
The sum of the committed information rate values for all band-
width and expedite commands defined within a policy must not
exceed the available link bandwidth of the interface to which that
policy is assigned. Violation of this requirement shall prevent
successful attachment of a policy to the interface, or shall cause
this command to fail if the policy is already in service on one or
more interfaces.
Out
Bandwidth (all forms), Shape Peak
May 30, 2003 Beta Draft
9-17

Advertisement

Table of Contents
loading

Table of Contents