Configure Inbound Telnet Settings - NETGEAR S3600 Series User Manual

S3600 Series 8- or 16-Port 10G/Multi-Gigabit Ethernet Smart Switch with 2 SFP+ Ports
• RSA key: In the RSA Keys Management section, select the Delete RSA Keys
radio button.
• DSA key: In the DSA Keys Management section, select the Delete DSA Keys
radio button.
• ECDSA key: In the ECDSA Keys Management section, select the Delete ECDSA
Keys radio button.
7. Click the Apply button.
The key is removed.

Configure inbound Telnet settings

If you enable the inbound Telnet session capability, an authorized user can establish a
Telnet session to the switch.
To configure the inbound Telnet settings:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network,
or connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser and enter the IP address of the switch in the address field of
your web browser.
If you do not know the IP address of the switch, see Access the switch on-network
and connected to the Internet on page 25 or Access the switch off-network and not
connected to the Internet on page 32.
The Device Admin Password page displays.
If you did not yet activate your warranty, the Register to activate your warranty page
displays. For more information, see Register the switch on page 35.
3. Enter one of the following passwords:
• Enter your device admin password.
• If you previously managed the switch through the Insight Cloud Portal or Insight
app, enter the Insight network password for the last Insight network location.
For information about the credentials, see Credentials for the device UI on page 34.
4. Click the Login button.
The Dashboard page displays.
5. Select System > Protocols > Telnet.
The Telnet page displays.
6. Click the Allow Telnet toggle to enable or disable Telnet access:
Configure Switch System
Settings
122 User Manual