show macfilter
This command displays the Static MAC Filtering information for all Static MAC Filters. If <all> is
selected, all the Static MAC Filters in the system are displayed. If a macaddr is entered, a vlan
must also be entered and the Static MAC Filter information will be displayed only for that MAC
address and VLAN.
Format
MAC Address
VLAN ID
Source Port(s)
Destination Port(s)
config macfilter create
This command adds a static MAC filter entry for the MAC address <macaddr> on the VLAN
<vlan>. The <macaddr> parameter must be specified as a 6-byte hexadecimal number in the
format of b1:b2:b3:b4:b5:b6.
The restricted MAC Addresses are: 00:00:00:00:00:00, 01:80:C2:00:00:00 to 01:80:C2:00:00:0F,
01:80:C2:00:00:20 to 01:80:C2:00:00:21, and FF:FF:FF:FF:FF:FF.
The <vlan> parameter must identify a valid VLAN.
Up to 100 static MAC filters may be created.
Format
config macfilter remove
This command removes all filtering restrictions and the static MAC filter entry for the MAC
address <macaddr> on the VLAN <vlan>. The <macaddr> parameter must be specified as a 6-byte
hexadecimal number in the format of b1:b2:b3:b4:b5:b6.
The <vlan> parameter must identify a valid VLAN.
Format
Switching Commands
7000 Series L3 Managed Switch Reference Manual for Software v1.0
show macfilter <macaddr vlan/all>
Is the MAC Address of the static MAC filter entry.
Is the VLAN ID of the static MAC filter entry.
Indicates the source port filter set's slot and port(s).
Indicates the destination port filter set's slot and port(s).
config macfilter create <macaddr> <vlan>
config macfilter remove <macaddr> <vlan>
May 30, 2003 Beta Draft
7-47