Show Router Ospf Interface Stats - NETGEAR GSM7324 Reference Manual

7000 Series L3 Managed Switch Reference Manual for Software v1.0
Subnet Mask
OSPF Admin Mode
OSPF Area ID
Router Priority
Retransmit Interval
Hello Interval
Dead Interval
LSA Ack Interval
Iftransit Delay Interval
Authentication Type
The information below will only be displayed if OSPF is enabled.
OSPF Interface Type
State
Designated Router
Backup Designated Router
Number of Link Events
Metric Cost

show router ospf interface stats

This command displays the statistics for a specific interface. The information below will only be
displayed if OSPF is enabled.
8-10
Is a mask of the network and host portion of the IP address for the
OSPF interface. This value was configured into the unit. This is a
configured value.
States whether OSPF is enabled or disabled on a router interface.
This is a configured value.
Represents the OSPF Area Id for the specified interface. This is a
configured value.
A number representing the OSPF Priority for the specified inter-
face. This is a configured value.
A number representing the OSPF Retransmit Interval for the
specified interface. This is a configured value.
A number representing the OSPF Hello Interval for the specified
interface. This is a configured value.
A number representing the OSPF Dead Interval for the specified
interface. This is a configured value.
A number representing the OSPF LSA Acknowledgement Inter-
val for the specified interface.
A number representing the OSPF Transit Delay for the specified
interface. This is a configured value.
The OSPF Authentication Type for the specified interface are:
none and simple. This is a configured value.
Broadcast LANs, such as Ethernet and IEEE 802.5, take the value
'broadcast'. The OSPF Interface Type will be 'broadcast'.
The OSPF Interface States are: down, loopback, waiting, point-
to-point, designated router, and backup designated router. This is
the state of the OSPF interface.
Is the IP address representing the designated router.
Is the IP address representing the backup designated router.
The number of link events.
Is the cost of the ospf interface. This is a configured value.
May 30, 2003 Beta Draft
Routing Commands