Config Diffserv Class Match Srcl4Port Keyword; Config Diffserv Class Match Srcl4Port Number - NETGEAR GSM7324 Reference Manual

7000 Series L3 Managed Switch Reference Manual for Software v1.0
Default
Format

config diffserv class match srcl4port keyword

This command adds to the specified class definition a match condition based on the source layer 4
port of a packet using a single keyword notation. The
DiffServ class. The value for
below). The optional
class (i.e., match all source layer 4 port numbers except for the one specified here).
The currently supported
snmp, telnet, tftp, www
as both the start and end of a port range.
Note: The srcl4port keyword, number, and range commands are alternative ways to specify a
source layer 4 port range as a match criterion.
Default
Format

config diffserv class match srcl4port number

This command adds to the specified class definition a match condition based on the source layer 4
port of a packet. The
number is required. The port number is an integer from 0 to 65535. The optional
parameter has the effect of negating this match condition for the class (i.e., match all source layer 4
ports except for the one specified here).
Note: The srcl4port keyword, number, and range commands are alternative ways to specify a
source layer 4 port range as a match criterion.
Default
Format
9-12
none
config diffserv class match srcip <classname> <ipaddr>
<ipmask> [exclude]
is one of the supported port name keywords (listed
<portkey>
parameter has the effect of negating this match condition for the
[exclude]
values are:
<portkey>
. Each of these translates into its equivalent port number, which is used
none
config diffserv class match srcl4port keyword <class-
name> <portkey> [exclude]
is the name of an existing DiffServ class. One layer 4 port
<classname>
none
config diffserv class match srcl4port number <class-
name> <0-65535> [exclude]
May 30, 2003 Beta Draft
is the name of an existing
<classname>
domain, echo, ftp, ftpdata, http, smtp,
CLI Commands: Differentiated Services
[exclude]