Conventions - NETGEAR GSM7324 Reference Manual

logical slot.port

Conventions

Network address are used to define a link to a remote host, workstation or network. Network
addresses are shown using the following syntax:
Table 1. Network Address Syntax
Address Type
ipAddr
macAddr
Double quotation marks such as "System Name with Spaces" set off user defined strings. If the
operator wishes to use spaces as part of a name parameter then it must be enclosed in double
quotation marks.
Entering '@' in front of any command will allow the user to reference any root command from
anywhere in the tree. For example, '>config router>@show arp table' will display the ARP table
even though the command was not executed from the root level.
Command completion finishes spelling the command when enough letters of a command are typed
to uniquely identify the command word. The command may be executed by typing <enter>
(command abbreviation) or the command word may be completed by typing the <tab> or <space
bar> (command completion).
The value 'Err' designates that the requested value was not internally accessible. This should never
happen and indicates that there is a case in the software that is not handled correctly.
The value of '-----' designates that the value is unknown.
Command Line Interface Syntax
7000 Series L3 Managed Switch Reference Manual for Software v1.0
The <slot.port> field is composed of a valid slot number and a
valid port number separated by a period (.).
This parameter denotes a logical slot number and logical port
number assigned. This is applicable in the case of a LAG. The
operator can use the logical slot number and the logical port num-
ber to configure the LAG.
Format
A.B.C.D
YY:YY:YY:YY:YY:YY
May 30, 2003 Beta Draft
Range
0.0.0.0 to 255.255.255.255
(decimal)
hexidecimal digit pairs
5-3