Reset System; Ping - NETGEAR GSM7324 Reference Manual

reset system

This command resets the switch without powering it off. Reset means that all network connections
are terminated and the boot code executes. The switch uses the stored configuration to initialize
the switch. You are prompted to confirm that the reset should proceed. A successful reset is
indicated by the LEDs on the switch.
Format

ping

This command checks if another computer is on the network and listens for connections. To use
this command, configure the switch for network (in-band) connection (as described in the
np
FASTPATH 2402/4802 Hardware User Guide). The source and target devices must have the ping
utility enabled and running on top of TCP/IP. The switch can be pinged from any IP workstation
with which the switch is connected through the default VLAN (VLAN 1), as long as there is a
physical path between the switch and the workstation. The terminal interface sends, three pings to
the target station.
Format
Switching Commands
7000 Series L3 Managed Switch Reference Manual for Software v1.0
reset system
ping <ipaddr>
May 30, 2003 Beta Draft
7-69