Config Snmpcommunity Delete; Config Snmpcommunity Ipaddr; Config Snmpcommunity Ipmask - NETGEAR GSM7324 Reference Manual

7000 Series L3 Managed Switch Reference Manual for Software v1.0
Note: Community names in the SNMP community table must be unique. If you make multiple
entries using the same community name, the first entry is kept and processed and all duplicate
entries are ignored.
Default
Format

config snmpcommunity delete

This command removes this community name from the table. The name is the community name to
be deleted.
Format

config snmpcommunity ipaddr

This command sets an IP address for an SNMP community. The address is the associated
community SNMP packet sending address. The name is the applicable community name. The
community name may be up to 16 alphanumeric characters.
Default
Format

config snmpcommunity ipmask

This command sets a client IP mask for an SNMP community. The address is the associated
community SNMP packet sending address. The name is the applicable community name. The
community name may be up to 16 alphanumeric characters.
Default
Format
7-18
Two default community names: Public and Private. You can
replace these default community names with unique identifiers
for each community. The default values for the remaining four
community names are blank.
config snmpcommunity create <name>
config snmpcommunity delete <name>
0.0.0.0
config snmpcommunity ipaddr <ipAddr> <name>
0.0.0.0
config snmpcommunity ipmask <ipmask> <name>
May 30, 2003 Beta Draft
Switching Commands