Barcode Pen Overview - TESTO 300 XXL Instruction Manual

Main menu Memory

Barcode pen overview

46
The barcode pen automates the allocation of measurement
data to a location.
If a barcode label is attached on site, this can be read with
the barcode pen.
The barcode pen is connected to the RS-232 socket on the
bottom of the device and can be connected and
disconnected whilst the device is switched on.
Activate the barcode pen by holding the tip of the pen briefly
against a white surface, e.g. the barcode label. Then move
the pen evenly and quickly in direct contact across the
barcode pattern. A correct reading is indicated by a signal
tone.
The location is automatically accepted in the location list of
the testo 300 XXL and is selectzed as the active location. It
is unnecessary to read or manually enter the customer
number of the customer where you are measuring
beforehand with a PC or by hand into the testo 300 XXL.
When you visit a customer whose customer number is not
saved in the device, you can read the number directly on
site by the barcode into the testo 300 XXL. If the location
read by the barcode pen already exists in the testo 300
XXL, this is activated.
Note
Barcodes can be created and decoded with the evaluation
software.