Table of Contents
Advertisement
Measurement menu
Select "Input"
Activate "Parameter"
Select
"Cross section"
Select "Circle",
"Square",
"Rectangle", "Area"
Enter value for
"Circle", "Square",
"Rectangle", "Area".
E E n n d d
Respective set
or
value comes into
effect
Enter offset factor
C
ROSS SECTION
Enter the cross section as a parameter:
1 Connect probe, switch on control unit.
2 Activate the function menu with the
the function keys. Select the function key
and confirm with
3 Enter duct diameter:
- Press
key.
- From Main menu – Input – Parameter – Cross section
- Circle – input value (8.82 cm)
- Square – input value
- Rectangle – input value
- Length a – input value
- Length b – input value
- Area – Input value
4 Accept the respective entered value with function key
.
End
5 Go automatically to the menu "Offset factor" or press
to go back to measurement menu.
6 Start measurement with
Main menu Input
for control unit
key and one of
VOL
.
.
VOL
with
61
Advertisement
Table of Contents
