Cross Section - TESTO 300 XXL Instruction Manual

Zeroing phase
3 sec
2 x
Select input
Select "Parameter"
Select "Cross
section"
Select "Circle",
"Square",
"Rectangle", "Area"
C
ROSS SECTION
Enter the cross section as a parameter:
1 Connect the probe. Connect analyser box to control unit;
switch on control unit.
2 Change to the main menu with key
3 From Main menu – Input – Parameter – select "Cross
section" menu.
4 Enter duct diameter:
- Press key.
- Circle – input value
- Square – input value
- Rectangle – input value
- Length a – input value
- Length b – input value
- Area – input value
5 With function key
entered value and automatically branch to menu "Set
offset factor" or back to the measurement menu with
key .
Enter value for
"Circle", "Square",
"Rectangle",
"Area"
Main menu Input
for analyser box
, accept the respectively
End
E E n n d d
Accept the respectively
set value and branch to
menu "Set offset factor"
.
81