Table of Contents
Advertisement
Measurement menu
Select "Input"
Activate "Parameter"
Select "Density"
or
Enter the density
E E n n d d
Menu: "Set pitot
tube factor"
D
ENSITY
Note
Factory setting: 1293 g/m
If this value is not changed, this value is used for the
calculation. The individual values are not taken into account.
The temperature, relative humidity and absolute pressure
influence the air density at the measuring point. These
values can be entered.
When these values have been entered, the density is
calculated automatically.
Enter density as a parameter:
1 Connect probe, switch on control unit.
2 Change to the main menu with key
3 From Main menu – Input – Parameter – select the
"Density" menu.
4 Accept the current reading with key
"Input density" with the cursor keys.
5 With function key
to the menu "Input pitot tube factor" or with key
back to the measurement menu.
Current reading
comes into effect
Main menu Input
3
E E n n d d
, an automatic branch is made
for control unit
.
or select
,
59
Advertisement
Table of Contents
