Panasonic LJ-SK56A Installation Manual page 103

Safety Precautions
■ In the event of the following, stop operating and switch OFF the protection devices for the product
inside the distribution board.
Continued use may result in failure, electric shock
Contact the service/inquiry counter where you purchased/contracted this product.
• Emergency situations such as a major earthquake or fire.
• When the system is submerged in water
• When the system is emitting smoke, strange odours or generating abnormal sounds
Mandatory
• When the earth leakage breaker in the residential distribution board is activated frequently.
• When the defective appearance caused by impact such as a vehicle collision.
■ If the battery electrolyte is leaking, do not touch the liquid with bare hands. If the electrolyte comes into
contact with your hands, wash them immediately with clean water. The electrolyte solution can cause
damage to the skin or cause blindness in the eyes. Seek medical attention immediately.
■ Unless required, refrain from touching the product while it is operating.
Do not touch the product while it is operating since it may be hot. Doing so may result in burns. Use
extra caution if you have small children and/or elderly family members.
■ Do not place objects on top of the product.
There is a risk of the objects
■ Do not put stickers on the product.
Prohibited
Doing so may result in failure because of rising temperature of the product.
■ Do not expose to excessive steam, oil vapour, smoke, dust, corrosive substances, explosive/
flammable gases, chemicals, fire or exhaust gas from vehicles.
There is a possibility that the products of degradation progress.
■ Allow sufficient space (at least below lengths) around the product for heat dissipation.
(Upper 200mm Right 50mm Left 200mm Front 800mm Back 50mm)
Failing to do so may cause the inside temperature to rise excessively, resulting
Mandatory
product life.
Stand-alone operation
■
■ Do not plug the following electric equipment into the output connected to the stand-alone socket:
• Any medical devices or security equipment
• Equipments that might lose information during power failure such as desktop computer.
• Kerosene heaters or any heating equipment that starts automatically when the power supply is restored.
The product will stop operating when the power consumption of the electrical equipment plugged into the
Prohibited
outlet connected to the stand-alone socket exceeds the maximum output power of the product.
Never connect any electrical equipment that may pose a threat to human life or properties in the event
of a power failure.
■ Inspect the product as described in the User's Manual, and start the stand-alone operation after
verifying that the product and the electrical equipment to be connected to the stand-alone socket
are in a safe condition.
■ Immediately stop operating if smoke, strange odours or abnormal sounds are produced from the
Mandatory
product or the electrical equipment connected to the stand-alone socket after starting the stand-alone
operation.
or fire.
catching fire from the heat generated during the operation.
in fire, failure or shorter
3