Panasonic LJ-SK56A Installation Manual page 98

9-3. Checking the Network Adaptor Communications
Operation Procedure
■
Status Selection
Status 1
Status 2
or
Status 3
• Press "CLOCK (▼)"+"DATA (▲)" for three seconds in the normal state to open the status selection mode.
• Press "DATA (▲)" or "CLOCK (▼)" to display the system status (S1).
• The first digit indicates the communications status with the Network Adaptor.
• [ ] indicates that the communications with the Network Adaptor is operating normally; and [
in operation. Make sure that the display for the 1st digit turns to [
If the Communications with the Network Adaptor are not Functioning
■
• The Network Adaptor may not be running. Check whether the protection device for Network Adaptor is turned ON.
• The communications line may be connected incorrectly. Check chapter 6-1 in the "Installation" section again and
verify that the communications line is connected correctly to both the Network Adaptor and the storage battery
system.
98
or
or
1st digit : Network Adaptor Communication Status
2nd digit : AC Voltage Status
3rd digit : DC Voltage Status
+
3 sec
1 sec
: OK(Normal state)
: NG (Error state)
].
Normal State
Stopped (Grid-connected)
Stopped (Stand-alone)
]appears if it is not