Preparation
■
• See 7-2 and switch to the Parameter Item Selection mode showing the initial display [no4.13].
Operation Procedure
■
• While [no4.13] is displayed, press "MENU (ENTER)" to switch to the Parameter Display mode.
• While the Parameter Display mode is selected, press "DATA(▲)" or "CLOCK(▼)" and select the parameter item.
Then press "MENU (ENTER)" to switch to the Parameter Setting mode. Or press "ON/OFF (CANCEL)" to return
to the Parameter Item selection.
• While the Parameter Setting mode is selected and digits are blinking, press "DATA(▲)" or "CLOCK (▼)" and
adjust the parameter level.
• After the adjustment of the parameter level, press "MENU (ENTER)" to fix the parameter level. Or press
"ON/OFF (CANCEL)" to cancel. Then return the Parameter Display mode.
• After returning the Parameter Display mode, press "ON/OFF (CANCEL)" to return the Parameter Item Selection.
Parameter Item
Selection
Characteristic
Power Factor Curve
or
90
Parameter
Display Mode
Characteristic
Power(P1)
CosΦ of Point1
(λ1)
Source or Sink
Setting(λ1)
Characteristic
Power(P2)
CosΦ of Point2
(λ2)
Source or Sink
Setting(λ2)
Parameter
Setting Mode
Characteristic Power
(P1)
or
CosΦ of Point1
(λ1)
or
Source or Sink Setting
(λ1)
or
Characteristic Power
(P2)
or
CosΦ of Point2
(λ2)
or
Source or Sink Setting
(λ2)
or