Panasonic LJ-SK56A Installation Manual page 81

Preparation
■
• See 7-2 and switch to the Parameter Item Selection mode showing the initial display [no4.06].
Operation Procedure
■
• While [no4.06] is displayed, press "MENU (ENTER)" to switch to the Parameter Display mode.
• While the Display mode is selected, press "DATA(▲)" or "CLOCK(▼)" and select the parameter item. Then press
"MENU (ENTER)" to switch to the Parameter Setting mode. Or press "ON/OFF (CANCEL)" to return to the
Parameter Item selection.
• While the Parameter Setting mode is selected and digits are blinking, press "DATA(▲)" or "CLOCK (▼)" and
adjust the parameter level. (If digits are not blinking, you can not change the value.)
• When the numerical parameter is 4 or 5 digits, at first set the numerical number in front of the decimal point, and
press "MENU", set the numeric number behind the decimal point.
• After the adjustment of the parameter level, press "MENU (ENTER)" to fix the parameter level. Or press "ON/OFF
(CANCEL)" to cancel. Then return the Parameter Display mode.
• After returning the Parameter Display mode, press "ON/OFF (CANCEL)" to return the Parameter Item Selection.
Parameter Item
Selection
The Power Rate
Limit Setting
or
Parameter
Display Mode
The Power Rate
Limit1 (WGra+)
The Power Rate
Limit2 (Wgra-)
The Power Rate
Limit3 (WGra+)
The Power Rate
Limit4 (Wgra-)
Parameter
Setting Mode 1
The Power Rate
Limit1 (WGra+) Setting
The Power Rate
Limit2 (Wgra-) Setting
The Power Rate
Limit3 (WGra+) Setting
The Power Rate
Limit4 (Wgra-) Setting
Parameter
Setting Mode 2
The Power Rate
Limit1 (WGra+) Setting
or
The Power Rate
Limit2 (Wgra-) Setting
or
The Power Rate
Limit3 (WGra+) Setting
or
The Power Rate
Limit4 (Wgra-) Settin
or
81