Setting Date/Time - Panasonic LJ-SK56A Installation Manual

5. Setting Date/Time

5-1. Date/Time
The date/time needs to be set for this system to operate normally. The Programmed charge/discharge time mode
cannot work correctly if the date/time is not set correctly.
If the ALARM LED is blinking in green, the date/time has not yet been set. Set the date/time.
The date/time setting is required when not connecting to the Network Adaptor.
The scheduled operation mode cannot work correctly if the date/time is not set.
When connecting with the Network Adaptor, the
However, the date/time needs to be set manually as an initial setting.
The work must be performed
5-2. Date/Time Setting
Preparation
■
• See the list of commands in P.52 to switch to normal state conditions.
Operation Procedure
■
Normal State
Stopped (Grid-connected)
Stopped (Stand-alone)
date/time notified by the Network Adaptor is given higher priority.
by qualified personnel.
3 sec
1 sec
Automatic
Date/Time Setting Mode
Year (initial)
Month
Day
Hour
Minute
Display of Setting
or
or
or
or
or
57