No4.04 Reactive Power Level Setting(Drm) - Panasonic LJ-SK56A Installation Manual

7-8. Reactive Power Level Setting (DRM)
In this setting mode, reactive power level can be set during DR operation.
Parameter Item
Reactive Power Level
Source Reactive Power
(DRM3)
Reactive Power Level
Sink Reactive Power
(DRM7)
Preparation
■
• See 7-2 and switch to the Parameter Item Selection mode showing the initial display [no4.04].
Operation Procedure
■
• While [no4.04] is displayed, press "MENU (ENTER)" to switch to the Parameter Display mode.
• While the Parameter Display mode is selected, press "DATA (▲)" or "CLOCK (▼)" to select the Parameter Item.
• After Parameter Item is selected, press "MENU (ENTER)" to switch the Parameter Setting mode. Or press
"ON/OFF(CANCEL)" to return Parameter Item Selection.
• While the Parameter Setting mode is selected and digits are blinking, press "DATA (▲)" or "CLOCK (▼)" to
adjust the value.
• After the adjustment, press "MENU (ENTER)" to store the data and switch to the Parameter Display mode.
Or press "ON/OFF(CANCEL)" to cancel parameter changed and return to the Parameter Display mode.
• Press "ON/OFF (CANCEL)" to return to Parameter Item Selection.
Parameter Item Selection
Reactive Power
Level Setting (DRM)
Table Reactive Power Level
Parameter
Selection Display
Parameter Display Mode
Source Reactive Power
(DRM3)
or
Sink Reactive
Power (DRM7)
Australia/New Zealand
Default Set Point
0%
0%
or
or
Range
0% ∼ 60%
0% ∼ 60%
Parameter Setting Mode
DRM3 Reactive Power
Level Setting
or
DRM7 Reactive Power
Level Setting
or
77