6-3. Password Input
Password authentication is required for changing the parameter values in the parameter setting mode. The following
illustration demonstrates how to enter the password.
Operation Procedure
■
Press this button to change the
The currently
Press this button to change the
value of the blinking digit.
• The currently
(3rd digit => 2nd digit => 1st digit => 3rd digit)
• The value of the selected digit changes each time "DATA (▲)" is pressed. (0 => 1 => 2 => ... => 9 => 0)
• Once all the digits have been set, press "MENU (ENTER)". The system then matches the entered value against the
correct password.
The system switches to the parameter selection mode if the password is correct. If the password is wrong, [Error]
appears for one second followed by the password prompt again.
• To abort the password input, press "ON/OFF (CANCEL)" for one second.
digit.
digit blinks.
digit blinks. The
Press this button after all the digits have been set.
When this switch is pressed, the system will start
matching the entered value against the correct
password.
The system switches to the parameter setting mode
if the password is correct. If the password is wrong,
[Error] appears for one second followed by the
password prompt again.
Press this button for one second to abort the
password input mode.
The system will return to normal state.
digit changes each time "CLOCK (▼)" is pressed.
61