7-18. Reverse Power Mode Setting
In this setting mode. thepropriety of reverse power flow from the storage battery system can be set.
However, if there in an instruction from DRED, it gives priority to the instruction of DRED not set here.
Parameter Item
Reverse Power
Mode Setting
Preparation
■
• See 7-2 and switch to the Parameter Item Selection mode showing the initial display [no4.14].
Operation Procedure
■
• While [no4.14] is displayed, press "MENU (ENTER)" to switch to the Parameter Display mode.
• While the Parameter Display mode is selected, press "MENU (ENTER)" to switch to the Parameter Setting mode.
Or press "ON/OFF (CANCEL)" to return to the Parameter Item selection.
• While the Parameter Setting mode is selected and the digit is blinking, press "DATA(▲)" or "CLOCK (▼)" and set
"0" (enable) or "1" (Disenable).
• After the selection, press "MENU (ENTER)" to store the data. Or press "ON/OFF (CANCEL)" to cancel. Then
return the Parameter Display mode.
• After returning the Parameter Display mode, press "ON/OFF (CANCEL)" to return the Parameter Item Selection.
Parameter Item Selection
Reverse Power
Mode Setting
Table DRM Mode List
Parameter Selection
Display
Parameter Display Mode
Reverse Power Mode
Australia/New Zealand
Default Set Point
0
or
Range
0 : enable
1 : disenable
Parameter Setting Mode
Reverse Power Mode
Setting
or
91