6. Setting Parameters for Installer
6-1. Setting Parameters
To operate this system normally, it is necessary to set the operation parameters. Note that the system may fail to
operate normally if these parameters are not properly set.
The system cannot operate normally if the parameters have not been set correctly.
The system must be operated by
parameter setting mode.
6-2. Switching to the Parameter Item Selection Mode
Preparation
■
• Set the storage battery system to the stopped state in the normal state. The system can only be switched to the
parameter setting mode while it is in a stopped state.
Operation Procedure
■
Normal State
Stopped (Grid-connected)
Stopped (Stand-alone)
• Press "DATA (▲)" + "MENU (ENTER)" simultaneously for three seconds to switch to the password input mode.
• Enter the password when prompted. The system switches to the parameter selection mode if the entered password
is correct.
(See 6-3 Password Input for details on the password input mode)
• The initial display [no 1-1] of the parameter item selection mode appears if the mode switch is successful.
• To return to the normal state, press "ON/OFF (CANCEL)" for one second while in the password input mode or
parameter item selection mode.
• If the password is unsuccessfully entered three times, or the operation buttons are not operated for a span of ten
minutes, it reverts to the normal state.
60
a qualified personnel. Password authentication is required for switching to the
Password Input
+
Password
3 sec
987
1 sec
Parameter Item Selection
Network Adaptor
Communications Setting
Password match
Initial Display