6-5. Network Adaptor Communications Setting
This system features a function for performing remote control and data communications via communications with the
Network Adaptor.
The Network Adaptor communications setting is
The work must be performed by
The Network Adaptor communications setting is not required for Stand-alone System, as the system is not
connected to the Network Adaptor.
Preparation
■
See 6-2 to 6-4 and switch to the parameter item selection mode showing the initial display [no 1-1]. Then select [no 1-1]
and press "MENU(ENTER)" to switch "Network Adaptor Connection [c1-00]".
Operation Procedure
■
Parameter Item
Selection (See 6-4)
* Only while [no 1-1] is
being displayed
Display Example
(1)
(2)
(1) Displays the setting item.
c1/ Network Adaptor
connection setting
c2/ ID display
(2) Displays the current
setting value.
in this section.
personnel.
Display Mode
Network Adaptor
Connection (Initial Display)
or
Communications
ID
Setting Mode
Network Adaptor
Connection
or
Communications ID
or
up
down
up
down
63