Panasonic LJ-SK56A Installation Manual page 30

2) Battery wiring
Connect the harness for the battery COM-IN connector and battery COM-OUT connector which is blocked into the
battery in the system, then remove the connector cover, and connect the battery power connector. Connect them
to all two batteries.
(SB1 does not have "COM-OUT")
* Match the battery number with the harness block number. (Connect an SB1 harness block to an SB1 battery.)
* Check connection by pulling gently, to make sure that it is securely connected.
Connection Check
●
The Battery is not wet.
No leakage of electrolytes from the Battery.
The DC protector is OFF.
No mistakes in the wiring.
The COM connectors (IN, OUT) are connected securely.
The battery power connectors (SB1, SB2) are connected securely.
30
Connector
Cover
SB2
Connector
Cover
SB1