Panasonic LJ-SK56A Installation Manual page 34

Preparation
■
Be sure to turn OFF the protection device for the Lithium-ion storage battery system, the Stand-alone breaker and
DC protector.
Be sure there is no voltage at all of the terminals.
Retracting the Cable
■
Check the outer diameter of the cables and feed it through the
1) Applicable cable sizes for the cable glands
Cable Gland
CT
COM
SYS
DRM
GRID - INTERACTIVE
STAND - ALONE
* Please use copper wire cables.
* See 1-1. Power and Communication Line Configuration for the cable details.
2) How to retract cables from the cable glands
This procedure is performed only where necessary.
(1) Push the rubber seal of cable
gland surface with a screw driver
from the bottom side of the
enclosure gently.
Put screw driver toward the inner
edge and break the rubber seal
from the inside.
Rubber seal
Cap nut
34
Applicable Cable
Diameter (mm)
Φ5 - Φ10
Φ5 - Φ10
Φ5 - Φ10
Φ5 - Φ10
Φ6 - Φ12
Φ6 - Φ12
(2) The screw driver tip will
come out when the rubber
seal is broken through.
Then press the seal horizontally
to the unopened parts to enlarge
the open area.
Screw Driver
cable glands.
Specified Cable
PVC Flexible Cable 2C 0.75 mm
PVC Flexible Cable 2C 0.75 mm
PVC Flexible Cable 2C 0.75 mm
CAT5e ( 10BASE - T/100BASE - TX )
PVC Circular Cable 2C+E 2.5 mm
PVC Circular Cable 2C+E 2.5 mm
2
2
2
2
2
(3) When the rubber seal is almost
open, tear it up with your hands
slightly.
Now you have an open seal.
Then remove the burr around the
cap nut.
Rubber seal