Panasonic LJ-SK56A Installation Manual page 85

7-13. Reactive Power Mode Setting
Select the reactive power mode from table listed below
Parameter Item
Reactive
Power Mode Setteing
Mode
0 All disenable
1 Volt-var response mode only enabled
2
Fixed reactive power mode only enabled
3 Fixed power factor mode only enabled
4 Characteristic power factor mode only enabled
Preparation
■
• See 7-2 and switch to the Parameter Item Selection mode showing the initial display [no4.09].
Operation Procedure
■
• While [no4.09] is displayed, press "MENU (ENTER)" to switch to the Parameter Display mode.
• While the Display mode is selected, press "MENU (ENTER)" to switch to the Parameter Setting mode. Or press
"ON/OFF (CANCEL)" to return to the Parameter Item selection.
• While the Parameter Setting mode is selected and the digit is blinking, press "DATA(▲)" or "CLOCK (▼)" and
select the value from 0 to 4.
• After setting the value, press "MENU (ENTER)" to store the data and switch to the parameter display mode.
Or press "ON/OFF (CANCEL)" to cancel. Then return the Parameter Display mode.
• After returning the Parameter Display mode, press "ON/OFF (CANCEL)" to return the Parameter Item Selection.
Parameter Item Selection
Reactive Power
Mode Setting
Table Reactive Power Mode
Parameter
Selection Display
*
Explanation
Parameter Display Mode
Australia/New Zealand
Default Set Point
*
0
or
Range
*
0 - 4
Parameter Setting Mode
or
85