Using A Headset To Make And Receive Calls; To Make Calls With Your Headset; To Answer Calls With Your Headset - NEC UNIVERGE DT700 User Manual

To make calls with your headset

1
2
3
4
Figure 7.21 Headset icon and Headset softkey
5

To answer calls with your headset

1
Figure 7.22 Answer key
2
7-108
B A S I C P H O N E O P E R A T I O N
Basic Call Operation
If you have problems reconnecting to a call after it is put on hold, press the EndCall
softkey to terminate the call.
U S I N G A H E A D S E T T O M A K E A N D R E C E I V E C A L L S
If you have a headset attached to your phone and your phone has been configured
for the headset (see "To enable an external headset" on page 4-67), you can either
use the telephone handset or your headset when you make and receive calls.
You cannot attach a headset to DT710 phones.
Note:
If you are using a headset, it is assumed that the telephone handset in the on-hook
position when you are making calls.
Press the NewCall softkey to receive dial tone.
Enter the telephone number.
Press the Dial softkey to initiate the call, or wait a few seconds for the call to be
automatically dialed.
You can also dial the number, then press the Headset softkey to initiate a call.
Note:
A Headset icon displays on the LCD along with the call information.
If you want to transfer the call to your telephone handset, pick up the telephone handset
to continue the call. If you want to transfer back to the headset, press the
Headset softkey, then place the telephone handset back on-hook.
While you are on a call, if you press the Headset softkey while the telephone
Note:
handset is on-hook, your call will be dropped. Make sure you pick up the
telephone handset to continue your call before you press the Headset softkey.
If you are using a headset, it is assumed that the telephone handset in the on-hook
position when you are answering calls.
While the telephone is ringing, press the Answer key.
A Headset icon displays on the LCD along with the call information.
DT700 Phone User Guide