To Pickup A Call On A Park Extension; Call Back Key; Using The Call Back Key; To Reset The Number For A Call Back Key - NEC UNIVERGE DT700 User Manual

To pickup a call on a Park Extension

•

Using the Call Back Key

•
Figure 9.38 ITL-8LD Secondary Screen, Call Back set

To reset the number for a Call Back key

1
2
Figure 9.39 CB Reset soft key

To clear Call Back

1
2
DT700 Phone User Guide
D T 7 0 0 M I C R O B R O W S E R A N D E N H A N C E D P R O G R A M M A B L E K E Y S
While your phone is idle and the Park Extension LED is flashing, do one of the following:
• To place a hands-free or headset call: Press the Park Extension key, then use
your headset or the phone's speaker to continue the call on your phone.
• To use your phone handset for the call: Pick up your phone handset, then
press the Park Extension key to pick up the call from that address.
C A L L B A C K K E Y
A Call Back key is used to set call back for the last dialed number. For other users
where you can monitor presence, the key is also set with presence monitoring
information.
Press the Call Back key to set call back to the last dialed number.
If the number can be monitored for presence, the key will show presence information
for the number.
The key stays configured for call back to that number until the number is dialed or call
back is manually cleared. If you attempt to place a new call to another number and
then want to set call back for that number, you must reset the Call Back key.
If you already have a Call Back key configured with a number and want to change the
number that the key is programmed for, you must reset the key.
Press the configured Call Back key.
Press the CB Reset soft key.
Press the Call Back key.
Press the CB Clear soft key.
Using Enhanced Programmable Keys
9-205