To Set The Hold Reminder Volume - NEC UNIVERGE DT700 User Manual

Figure 4.26 Tone Volumes options
5
Figure 4.27 Call Waiting volume
6
Figure 4.28 Adjust Call Waiting Volume
7

To set the Hold Reminder volume

1
2
3
4-70
B A S I C S E T T I N G S / C O N F I G U R A T I O N
Basic Setup with the Menus and Cursor Pad
1
Select Call Waiting Volume.
To change the volume level, press the Delete softkey and use the telephone keypad to
enter new volume level.
b
Press Enter on the cursor pad or the OK softkey to accept the setting.
You can also press the Cancel softkey to exit without making any changes.
The setting defaults to 19 (maximum tone volume).
Note:
The Hold Reminder Volume settings allow you to specify the hold reminder volume for
the headset.
The range is 0 (no tone) to 19 (maximum tone volume). The default is 19.
Upon entering this screen, the keypad is locked in numeric entry mode. You cannot
change the keypad entry mode in this screen.
Press the Menu key.
3
Select User Settings.
2
Select Headset.
DT700 Phone User Guide