To Install Dcl-60 Line Key Card (Optional) - NEC UNIVERGE DT700 User Manual

Figure 3.34 Screw DCL-60 module to the connector bracket
4
Figure 3.35 Serial Cable Installed
5
6
7
8
9
10
To install DCL-60 Line Key Card ( Optional)
1
2
3
DT700 Phone User Guide
Connect the 10 pin connector to the SIDE 2 port on the back of the phone.
Cable Port
Port Cover
Adjust the height of the tilt leg on the phone to the desired height.
Adjust the height of the tilt leg on the DCL-60 to match the tilt leg on the multiline
terminal.
Attach the side panel to the side of the DCL-60.
Connect the AC Adapter cable to the DCL-60.
Reattach the side panel to the phone.
Connect power to the phone.
From the bottom, use an object to gently pry off the button panel for the DCL-60 module.
Align the holes in the Line Key Card with the buttons on the phone.
Align the holes in the Button Panel with the telephone keypad buttons on the phone, and
then push the four corners of the panel until the panel clicks into place.
I N S T A L L A T I O N
3-59