Dcl-60 Console (Type A) - NEC UNIVERGE DT700 User Manual

8-126
P R O G R A M M A B L E K E Y S
Speed Dial and Programmable Keys
O P T I O N A L P R O G R A M M A B L E K E Y M O D U L E
Additional Programmable Keys may also be added by installing the optional
Programmable Key Module. ITL-32D phones come with the 8LK-L already attached.
The following table lists the Programmable Key Modules that are supported by the
DT700 series of phones:
Product Name
DT710
DT730
DT730G
8LK-L Key Numbering
Key numbering for the 8LK-L module always uses key numbers 25 through 32, no
matter how many keys are on the original phone. If the 8LK-L module is installed on a
ITL-12D phone, there is a gap in the numbering of the Speed Dial keys (key numbers
2 to 12 on the phone, key numbers 25 to 32 on the 8LK-L module).
D C L - 6 0 C O N S O L E ( T Y P E A )
Feature Support by Model
The DT730 phones support the DCL-60 Console (Type A) connected to the UART
Side 2 Connector port to add an additional 60 line keys on the phone.
Each of these keys can be programmed as a Speed Dial key, programmable Key or
Enhanced Programmable Key (Record, Park, Hot Desk key, etc).
Speed Dial keys can be configure on the DCL-60 Console to allow the phone to
monitor the status or presence of other users.
Only one connection to the Side 2 connector port is available on the phone, so
Note:
the phone can only support a DCL-60 console OR a Jabra headset. Both
cannot be connected to the same phone at the same time.
M A X I M U M N U M B E R O F L I N E K E Y S W I T H T H E D C L - 6 0
The following tables describe the maximum number of line keys supported on each
DT700 model when DCL-60 configuration modes is enabled. It also specifies the
Programmable Key
Model
Module Support?
ITL-2E
ITL-6DE
ITL-8LD
ITL-12D
ITL-24D
ITL-32D Factory Installed
ITL-12CG
ITL-24CG
ITL-12DG
ITL-24DG
Module
No N/A
No N/A
No N/A
Yes 8LK-L
Yes 8LK-L
8LK-L
Yes 8LK-L
Yes 8LK-L
Yes 8LK-L
Yes 8LK-L
DT700 Phone User Guide