To Log Out Of Your Hot Desk Session; Trunk Dial Key; To Seize A Trunk To Place A Call - NEC UNIVERGE DT700 User Manual

To log out of your Hot Desk session

1
2
Table 10.4

To seize a trunk to place a call

•
10-250
D T 7 3 0 G C O L O R M I C R O B R O W S E R A N D E N H A N C E D P R O G R A M M A B L E K E Y S
Enhanced Programmable Keys
While you are in a Hot Desk session, press the Hot Desk Key.
You are logged out off the phone, and the following screen is shown:
Press OK to exit the screen.
The LED on the Hot Desk key turns off when you exit this screen.
T R U N K D I A L K E Y
The Trunk Dial key is used to monitor the availability of trunks on your system, and to
place calls using specified trunks on the system.
T R U N K P R E S E N C E L E D S
Trunk Presence LEDs
LED
LED is not Trunk not registered with the system
lit
Trunk is not in service
Green Trunk channels available to make outside calls
Red Busy - All trunk channels are occupied.
When the Trunk Dial key LED is green
the Trunk Dial key.
If the trunk is online and in service and there is an available line on the trunk, the
phone will allow you to dial a number to place a call. If the trunk is not available, the
phone will not enter the dialing state. You must wait for the trunk to become available,
or use another Trunk Dial key to access different trunk.
You can enter the number using the keypad
Using a Speed Dial key, or a Personal or Corporate directory to dial the
Note:
number is not supported. If you use a Speed Dial key or navigate to a Personal
or Corporate directory entry, it overrides Trunk dialing and the call is placed as
a normal outbound call to the configured number.
D N D K E Y
The DND key can be used to enable and disable Do Not Disturb on your phone. If
configured for your system, it can also serve as an indicator of DND status on the
system. The key will reflect the DND status as set by the phone, star codes, or set
using a supported client application.
Comments
to indicate that the trunk is available, press
DT700 Phone User Guide