Table of Contents
Advertisement
To pickup a held call from a member of your workgroup
•
To place a call to a member of your workgroup
•
1
2
1
2
3
Figure 10.32 Transfer Key
10-246
D T 7 3 0 G C O L O R M I C R O B R O W S E R A N D E N H A N C E D P R O G R A M M A B L E K E Y S
Enhanced Programmable Keys
The default type of transfer (blind or consult) for this key is controlled by your
Note:
system administrator.
When another user has a call on hold, you will see a red flashing LED for that user.
While your phone is idle and the other workgroup member's phone has a held call, do
one of the following:
• To place a hands-free or headset call: Press the key for the workgroup
member, then use your headset or the phone's speaker to continue the call on
your phone.
• To use your phone handset for the call: Pick up your phone handset, then
press the key for the workgroup member to pick up the call from that address.
M U L T I - P R E S S B E H A V I O R
You can use a programmed key to place calls to other workgroup members.
While your phone and the other workgroup member's phone is idle, do one of the
following:
To place a hands-free or headset call:
Press the key for the workgroup member you want to call.
An outbound call is made to the workgroup member.
Use your headset or the phone's speaker to continue the call on your phone.
To use your phone handset for the call:
Pick up your phone handset.
Press the key for the workgroup member.
An outbound call is made to the workgroup member.
Continue the call on your phone.
Non-idle call states:
• If you are on a call, you will see a screen that gives you the option to Blind transfer
your currently held call to that workgroup member.
If you actually want to place an attended/consult transfer call rather than a
Note:
Blind transfer call, press the Transfer key on your phoneset. Once an
attended/consult transfer is started, use the Transfer key on the phoneset to
complete the transfer.
DT700 Phone User Guide
Advertisement
Table of Contents
Troubleshooting
