Headset Base Station Setup; Enable The Headset Port On Your Phone - NEC UNIVERGE DT700 User Manual

1
2
Table D.1
3

Headset Base Station Setup

•

Enable the Headset port on your phone

1
2
3
DT700 Phone User Guide
J A B R A B L U E T O O T H ® H E A D S E T S U P P O R T F O R D T 7 0 0 P H O N E S
will need to enable the connector for the DCL-60 Line Key Module at each
phoneset device with a line key module if you change the setting in the master
configuration file.
Open the default master configuration file:
DT700 phones: dt-000000000000.cfg
DT730G phones: dt-000000000000g.cfg
Edit the configuration file so the value for the mntn.dcl.option is "2" to support the Jabra
Headset Kit.
Side 2 connector Operation Modes
XML Tag Range
mntn.dcl.option 0 – Debug
Console
1 – DCL-60
2 - Jabra
Headset Kit
Restart all phones on the network to fully activate the Side 2 connector for the Jabra
Headset Kit. The Side 2 connector on all phones in your network will be enabled for the
Jabra Headset Kit.
Follow the manufacturer's instructions for assembling your headset and base station.
Do not connect the power adapter to the headset base station yet. If you have already
connected the power adapter, unplug it from the wall outlet and the headset base
station.
Press the Menu key on the phone.
3
Select User Settings.
2
Select Headset.
Description
Not supported.
Default. Selects the DCL-
60 Line Key Module
mode for the Side 2
connector.
Note: The DCL-60 Line
Key Module is currently
the
only available on 3C
system.
Selects the Jabra
Headset Kit mode for the
Side 2 connector
Jabra Headset
D-331