For A System That Is Already Installed; Logging Into The Wireless Alarm System; Logging Out From The Wireless Alarm System - Abus SECVEST Installer Manual

Note
It is sometimes beneficial to use a fixed IP
address instead of a dynamically assigned IP
address (DHCP).
Some routers assign other IP addresses to their
clients after a certain time, for example. Other
devices do not recognise this new IP address yet.

For a system that is already installed

1. Log into the wireless alarm system as an installer.
2. Navigate to the following submenu:
Info>Communications>Ethernet.
3. Make a note of the IP address.
4. Log out of the alarm panel.
5. Open the web browser on your PC and enter the
IP address indicated by the alarm panel.
6. Open the web browser on your PC and enter the
IP address indicated by the alarm panel.
7. Enter your user name and password to log onto
the web server.

Logging into the wireless alarm system

1. Open the web browser.
2. Enter the IP address in the following form:
xxx.xxx.xxx.xxx.
The browser then switches to https automatically.
Note
If a user (operator, installer) is logged in directly to
the wireless alarm system, it cannot be accessed
via web browser for security reasons.
Note
Depending on the browser, a message may
appear, indicating that the connection/certificate is
unsafe.
Confirm the security exception rule and save it.
3. Load the page. The login screen appears.
4. Log in as an Installer with the user name and the
installer password.
Note for S/W <1.01.00
The default installer password is 9999(99)
5. Click on the Login button or press the enter key
on the keyboard.
6. The main menu appears:

Logging out from the wireless alarm system

Click the Log out button.
If you are working directly in the alarm control panel, click
the "Exit" menu key.
Important!
Saving the settings:
S/W <2.00.00
When you make these changes in the Installer Mode, the
Secvest stores these changes in temporary storage until
you leave the Installer Mode.
When you leave the Installer Mode, the alarm control
panel writes these changes to permanent storage.
If you power off the alarm control panel completely
BEFORE leaving the Installer Mode, the alarm control
panel will lose all your changes.
Please note that this does not apply if you restore the
factory defaults; this change is implemented immediately.
S/W >=2.00.00
When you make these changes in the installer mode,
they will be saved directly in the Secvest's permanent
storage following confirmation.
They will be preserved, even in the event of power failure
before you exit installer mode.
Important!
Commissioning
25