Abus SECVEST Installer Manual page 195

User Reset
Zone Alarms
Zone Tampers
System Tampers
Confirmation
Confirmation mode
Basic
DD243
BS8243
Confirmation time
After Entry
Entry Keypad Lock
Sounder On
Siren On
Unconfirmed Reset
Confirmed Reset
Hold Up Alarm
confirmation time
Tamp as Tamp-Only
Hardware
Wired Zone Type
RF Siren Options
Battery 2
SD Card
GSM antenna
Security
Supervision
Jamming
Remote Updates
Tamper Omit
Force Set
Remote Unset Full Set
Yes
Yes
No
Default for systems apart from the
UK
Default for UK systems if the UK is
chosen as the country.
30 minutes
1 Zone
Off
Unconfirm
Unconfirm
User
Installer
8 hours
Enabled
2-wire FSL 2K2/4K7
Siren + Strobe
Disabled
Internal
Fault
Tamper when country = UK
Fault
Tamper when country = UK
Disabled
Disabled
Off
Always
This option only appears if the
confirmation mode is set to "Basic".
For INCERT detection, set to NO.
This value depends on how you
answer the "Country defaults"
question during initial commissioning.
This value depends on how you
answer the "Country defaults"
question during initial commissioning.
Visible for DD243 or BS8243.
Can be set to between 1 and
60 minutes. Ensure that only one
value of 30 minutes or more is
compliant with DD243 or BS8243.
Visible for DD243 or BS8243. The
default setting is changed to 2 zones
if the confirmation mode = DD243.
Visible for DD243 or BS8243.
Visible for DD243, BS8243 and Basic.
Visible for DD243, BS8243 and Basic.
Visible for DD243 or BS8243.
Visible for DD243 or BS8243.
Only visible for BS8243. Must be
between 8 and 20 hours to be
compliant with BS8243:2010.
Visible for BS8243.
This value depends on how you
answer the "Wired Zone
question during initial commissioning.
"TAMPER" for UK to fulfil
PD6662:2010
"TAMPER" for UK to fulfil
PD6662:2010
This setting is required to fulfil
EN50131.
If Force Set is enabled, the system
is not compliant with EN50131.
Appendix
Type"
195