Status - Abus SECVEST Installer Manual

Configuration

Status

No. Name/function
1 Partition selection
Selection fields/tabs for individual partitions:
 An alarm that is confirmed by the user but
not reset is displayed in the corresponding
partition as a warning symbol.
 Clicking this warning symbol
resets this alarm.
Only for the alarm control panel display
Note:
A "warning triangle" appears at the bottom of the display on the right-hand side if the alarm panel detects a problem.
The explanation (description of the problem) is not shown unless an access level 2 (user) or access level 3 (installer)
code is entered. After a valid code has been entered the message appears in plain text (problem, fault, warning,
alarm etc.) The message is hidden again once the user has acknowledged or confirmed it. The notification disappears
automatically after a one-minute time out.
37
No. Name/function
2 Status display
The status display contains information including:
 faults in the individual partitions
 Faults across partitions
(e.g. "Ext DC fault")
 open zones (across partitions)