Abus SECVEST Installer Manual page 60

Configuration
Delete All
Add RF repeater (alarm panel)
1. Select RF repeater.
2. Select Add/Del.
3. Select the corresponding repeater.
4. Trigger the tamper contact of the repeater.
Note
When a repeater has been taught in, the wireless
alarm panel beeps twice to confirm.
A message appears on the display to confirm that
the repeater was added, and the value for the
received signal strength is shown.
You can see the receiving signal strength of the
alarm panel on the repeater through the status
LEDs. Details on this can be found in the repeater
manual.
5. Exit the entry with Back.
Note
If a repeater has been taught in the symbol
appears next to the repeater number on the alarm
panel display.
A maximum of 4 repeaters can be added
6. Exit this display with Back.
60
". The following course of action is the same as is described for the alarm panel's
menu guidance below.
Click on this field and in the next step confirm the security prompt to delete all
repeaters.
Edit
Select the corresponding repeater.
The following sub-menu items appear.
Name:
Assign a unique name for this repeater.
Repeat alarm panel
Select whether wireless messages from the alarm panel
should be repeated by this repeater.
Note
Messages from the alarm panel could be:
Broadcast alarm panel status (is necessary for the
permanent display of the status of the partitions on
the control panel FUBE5000x).
Control of external sirens (e.g. FUSG50100 or
FUSG50000)
Control of internal sirens (e.g. FUSG50010) and
information modules (e.g. FUMO50030)
Control of wireless outputs (e.g. wireless socket
FUHA50010).