Abus SECVEST Installer Manual page 157

Walk test (cont.)
Report
The test results can also be printed out and saved via the web interface.
Alarm panel
System
All detectors belonging to the system can be tested here. Activate all detectors in the
building one after the other. If a detector is triggered the alarm panel emits two signal tones
It also indicates on the display whether a tamper contact (S) and/or alarm (A) was triggered.
The top of the display shows the number of zones still to be tested (alarm and tamper).
When all detectors have been tested the system writes "All Zones tested".
Partitions
 Detectors from a specific partition can be tested here.
 Once the partitions are selected only the detectors in the selected partitions are displayed.
Zones
 Selected detectors can be tested here.
A list of all detectors appears. Select the detectors to be tested with Yes.
Configuration
157