Omron NJ501-1400 User Manual page 52

1 Introduction to NJ-series Controllers
Refer to the NJ/NX-series CPU Unit Software User's Manual (Cat. No. W501) for details on the net-
work configuration.
 Support Software
You can use the following Support Software to set up, monitor, and debug an NJ-series Controller.
Sysmac Studio
The Sysmac Studio is the main Support Software that you use for an NJ-series Controller. On it, you
can set up the Controller configurations, parameters, and programs, and you can debug and simu-
late operation.
Other Support Software
The following Support Software is also included in the Sysmac Studio Software Package Standard
Edition.
Configuration software
Sysmac Studio
Network Configurator
CX-Integrator
CX-Protocol
CX-Designer
*1 If the NJ/NX-series Controller is a target device, you may also use Sysmac Studio version 1.10 or higher.
Use the Network Configurator if a CS/CJ-series PLC operates as the originator device.
1-6
The Sysmac Studio is used for sequence control, motion control, and all other
operations except those described below.
The Network Configurator is used for tag data links on EtherNet/IP ports or
*1
Units.
The CX-Integrator is used for remote I/O communications with a DeviceNet
Unit or CompoNet Master Unit.
The CX-Protocol is used for protocol macros with Serial Communications
Units.
The CX-Designer is used to create screens for NS-series PTs.
Application
NJ-series CPU Unit Hardware User's Manual (W500)