Omron NJ501-1400 User Manual page 165

Precautions for Correct Use Precautions for Correct Use
Always use the specified crimp tool to attach the crimp terminals. If a crimp tool is not used, the
cable will not be crimped properly, which may cause the cable to become detached from the ter-
minal.
The following crimp tools are available.
UD6 (Product code: 1204436)
or ZA3 Series
Crimper PZ1.5
(Product code: 900599)
NH77
3
Connecting Cables
Use the following procedure to connect cables to the connection terminals.
(1) Orient the connector properly, and then insert the signal lines fully into the back of
each terminal hole in the connector, as shown in the following diagram. (The signal
lines are secured in this way, without requiring the use of a tool.) If crimp terminals
are not used on the signal lines, use a small flat-blade screwdriver to press down on
the orange tab to insert the signal lines.
• Power Supply on One Side (Common Power Supply)
• Power Supply on Both Sides (Separate Power Supplies)
NJ-series CPU Unit Hardware User's Manual (W500)
Model
PHOENIX CONTACT
Nihon Weidmuller Co., Ltd.
NICHIFU Co., Ltd.
V1
SIG1
G1
SIG1
G1
4 Installation and Wiring
Manufacturer
4
4-45