Omron NJ501-1400 User Manual page 272

5 Troubleshooting
Event name Restore Operation Completed
Meaning The restore operation ended normally.
Source PLC Function Module
Error attributes Level
Effects User program
System-defined Variable
variables
_Card1RestoreSta
Cause and Assumed cause
correction
The restore operation ended nor-
mally.
Attached Attached information 1: Operation type
information
0101 hex: SD Memory Card to Controller for switch operation on front of CPU Unit
0102 hex: SD Memory Card to Controller for specification with a system-defined variable
0201 hex: Computer to Controller
Precautions/ None
Remarks
* This event code occurs for unit version 1.03 or later of the CPU Unit.
Event name SD Memory Card Program Transfer Started
Meaning Transferring the SD Memory Card programs was started.
Source PLC Function Module
Error attributes Level
Effects User program
System-defined Variable
variables
None
Cause and Assumed cause
correction
Transferring the SD Memory Card
programs was started.
Attached None
information
Precautions/ None
Remarks
*1 This event code occurs for unit version 1.11 or later of the CPU Unit.
5-92
Source details
Information Recovery
--- Operation
Data type
_sRESTORE_STA
Correction
---
Source details
Information Recovery
--- Operation
Data type
---
Correction
---
Event code 901D0000 hex*
None Detection
timing
--- Log category
Operation does not start after the completion of a restore
operation. To start operation according to the restored
user program and settings, turn OFF the power supply to
the Controller, turn OFF all pins on the DIP switch on the
CPU Unit, and then turn ON the power supply again.
Name
SD Memory Card Restore Status
Prevention
---
Event code
90200000 hex
None Detection
timing
--- Log category
Not affected.
Name
---
Prevention
---
NJ-series CPU Unit Hardware User's Manual (W500)
At end of normal
restore operation
System
*1
When transfer-
ring SD Memory
Card programs is
started
System