Omron NJ501-1400 User Manual page 131

Mounting with the DIN Track on the Bottom
DIN Track
Installation Method in Control Panels
An NJ-series Controller must be mounted inside a control panel on DIN Track. Normally the CPU Rack
is installed on top and the Expansion Racks under it.
• Consider the width of wiring ducts, wiring, ventilation, and Unit replacement when determining the
space between Racks.
• When you install Racks vertically, allow at least 66 mm between any two adjacent Racks.
Additional Information
A Controller must be mounted on DIN Track. It cannot be mounted with screws.
NJ-series CPU Unit Hardware User's Manual (W500)
Mounting with the Rack Upside down
4 Installation and Wiring
Mounting with the DIN Track on the Top
Mounting with the DIN Track Installed Vertically
DIN Track
DIN Track
4-11
4