Advertisement
CAPONORD 1200
Check the cable harness of the CAN line.
ENGINE TEMPERATURE
Error code B0010 (ENGINE OVERTEMPERATURE)
Error cause
Engine temperature > 115 °C.
Troubleshooting
The error is no longer displayed when the temperature falls below 113 °C. If the error continues to be
displayed also with low engine temperature, the failure is probably in the sensor that is shortcircuited
or in the cable harness: perform the diagnosis by connecting to the engine control unit.
HEATED HANDGRIPS
Error code B0011 (HANDGRIPS HEATING BUTTON LOCKED)
Error cause
Alarm handgrips button locked:
This alarm occurs when, for various reasons, the activation button is locked.
Identification
Fixed warning light.
Troubleshooting
Check the correct operation of the contact of the button and the insulation from ground and from supply
of PIN 15 of the instrument panel (grey connector).
Battery recharge circuit
RECHARGING SYSTEM
•
Remove the tank and the filter casing;
•
Disconnect the three-way connector
(1) (white).
NOTE
THE ENGINE SIDE IS IDENTIFIED WITH THE LETTER "A"
Measurement of resistance (with engine off)
•
For a correct detection of the alternator
resistance, an ambient temperature
measurement must be carried out and
afterwards a heat stabilisation (after
turning fan on) by using a tester, using
alternatively the 3 connector pins:
Electrical system
ELE SYS - 91
Advertisement
