CAPONORD 1200
Rear throttle Potentiometer 2 (voltage)
•
Example value with key ON: 4226 mV
•
Example value with engine on: 4372 mV
Key to throttle connectors figure:
•
A - Front cylinder throttle connector
•
B - Rear cylinder throttle connector
Front cylinder throttle Limp Home position
•
Example value with key ON: 878 mV
Voltage stored in the control unit corresponding to the Limp home position
Rear cylinder throttle Limp Home position
•
Example value with key ON: 888 mV
Voltage stored in the control unit corresponding to the Limp home position
Front throttle lower position
•
Example value with key ON: 502 mV
Voltage stored in the control unit corresponding to the throttle mechanical minimum position
Rear throttle lower position
•
Example value with key ON: 492 mV
Voltage stored in the control unit corresponding to the throttle mechanical minimum position
CAUTION
BEFORE CARRYING OUT ANY TROUBLESHOOTING, CAREFULLY READ THE GENERAL TROU-
BLESHOOTING CONCEPTS FOR ELECTRICAL DEVICES AT THE BEGINNING OF THE CHECK
AND CONTROL SECTION IN THE ELECTRICAL SYSTEM CHAPTER.
DIAGNOSIS INSTRUMENT: STATUSES
Front throttle automatic self-acquisition
•
ice/ interrupted/carried out/limp home/closed throttle stop/springs check/limp home self-ac-
quisition/initialise
Indicates if self-acquisition carried out by control unit has/has not been carried out: it is essential to
know if the last self-acquisition with key ON has been successful
Rear throttle automatic self-acquisition
•
ice/ interrupted/carried out/limp home/closed throttle stop/springs check/limp home self-ac-
quisition/initialise
Indicates if self-acquisition carried out by control unit has/has not been carried out: it is essential to
know if the last self-acquisition with key ON has been successful
Throttle self-learning with diagnostics instrument
•
carried out/not carried out
Electrical system
ELE SYS - 147