Advertisement
CAPONORD 1200
connector PIN 3 is a few tenths of an Ohm; If it is above that value, restore cable harness.
Replace the sensor if it is correct.
rear cylinder air pressure sensor P0108
•
signal not valid.
Error cause
•
According to the engine operation data (rpm, throttle, etc.) an average value for the intake
pressure is estimated: if the value read deviates by a given percentage, this error is activa-
ted. The most frequent causes can be: abnormal resistance in the sensor circuit (for
example, rusted terminals) or sensor with poor performance.
Troubleshooting
•
Check the Marelli control unit connector and the sensor connector; if not OK, restore. If
everything is OK, check that resistance between ENGINE connector PIN 49 and sensor
connector PIN 3 is a few tenths of an Ohm; If it is above that value, restore cable harness.
Replace the sensor if it is correct.
Error for unexpected air intake in the front cylinder manifold P0210
•
signal not valid.
Error cause
•
A small difference between the estimated pressure and the measured pressure has been
detected: the measured pressure is higher than the estimated one (intake manifold condi-
tions).
Troubleshooting
•
Check the conditions of the intake manifold and cleanliness of the hole for pressure reading.
Error for unexpected air intake in the rear cylinder manifold P0211
•
signal not valid.
Error cause
•
A small difference between the estimated pressure and the measured pressure has been
detected: the measured pressure is higher than the estimated one (intake manifold condi-
tions).
Troubleshooting
•
Check the conditions of the intake manifold and cleanliness of the hole for pressure reading.
Estimation error for front cylinder intake manifold pressure P0215
•
too high pressure/too low pressure.
Error cause
Electrical system
ELE SYS - 125
Advertisement
