CAPONORD 1200
•
Refill the fork with oil according to the
prescribed quantity.
•
Fit the spring.
CAUTION
BE CAREFUL WHEN INSERTING THE SPRING SINCE THE
COMPRESSED SPIRAL PART MUST BE PLACED DOWN-
WARDS.
See also
Filling oil
•
Insert the washer that will be supported
on the spring
•
Insert and hand tighten the nut on the
pumping member pin
•
Place the preload pipe.
•
Tighten the appropriate tool on the
pumping member pin rod and keep it
raised to allow, inserting a wrench in
the nut by compressing the spring.
Specific tooling
020890Y Pumping member stanchion support
rod
AP8140147 Spacer tool
Suspensions
SUSP - 317