Advertisement
Electrical system
between PIN 5 valve - PIN L2 VCU. If the cable harness is not damaged, replace the com-
ponent.
Error potentiometer exhaust valve shortcircuit C1707
Error cause
•
An excessive or null tension has been detected on PIN B4 VCU.
Troubleshooting
•
Disconnect the connector of the component and check its insulation from ground and supply
system of PIN 2: if the insulation is not present, restore the cabling, otherwise replace the
component.
Error potentiometer exhaust valve open circuit C1708
Error cause
•
An interruption of the circuit has been detected.
Troubleshooting
•
Check the connector on the component and the VCU connector. Disconnect the two con-
nectors and check the continuity of the cable between PIN 2 potentiometer and PIN B4 VCU
and restore the cable harness. If the cable harness is not damaged, replace the component.
Cruise Control Button
(IF APPLICABLE)
Function
Cruise Control is an electronic system that makes
it possible to set the desired speed and keep it
constant also in case of driving uphill or downhill,
without using the gas control.
The system is deactivated automatically when the
rider uses any of the brake/clutch controls or
Cruise Control button. It is very useful during long
motorway journeys, because it helps saving fuel
and makes riding less tiring.
Operation / Operating principle
To activate the function (switching from OFF to
ON), press and hold the Cruise Control button on
the handlebar for approximately 2 seconds: the
warning light on the instrument panel flashes to
indicate the ON status of the Cruise Control. The
set speed must be within the thresholds below:
ELE SYS - 168
CAPONORD 1200
Advertisement
