Advertisement
Electrical system
Check the mapping of the control unit and reset the vehicle configuration.
OIL SENSOR
Error code B0001 (OIL SENSOR FAILURE)
Oil motor low pressure alarm:
This alarm occurs when the engine is off and the pressure of the engine oil is low. If during the following
OFF-ON key switching, the fault is not immediately detected, the error is no longer displayed. Only in
case the fault occurs again after performing two TRIPs (minimum TRIP: 10 km) and following the third
OFF-ON key switching, the error is displayed again.
Identification
Oil warning light fixed.
Troubleshooting
Check the connector on the component and the instrument panel connector. Disconnect the two con-
nectors and check the continuity of the cable between the sensor and the PIN 17 of the instrument panel
(grey connector) and restore the cable harness. If the cable harness is not damaged, replace the sensor.
Error code B0002 (OIL PRESSURE FAILURE)
Oil sensor disconnected alarm:
This alarm occurs when the sensor is disconnected, rpm higher than 900.
Identification
Oil warning light flashing.
Troubleshooting
Disconnect the connector of the component and check the insulation from ground: if the insulation is
not present, restore the cabling, otherwise replace the sensor. It this error persists, use a pressure
gauge to check the pressure of the oil in the engine circuit.
CAN LINE
Error code B0008 (CAN LINE RECEPTION ERROR)
Error cause
The instrument panel is coded at the first key insertion, if the CAN line is missing, the error is activated.
Identification
Warning light on.
Troubleshooting
Check the cable harness of the CAN line.
Error code B0009 (CAN LINE TRANSMISSION ERROR)
Error cause
The instrument panel is coded at the first insertion of the key, if the received data do not coincide with
the memorised ones, the error is activated.
Identification
Warning light on.
Troubleshooting
ELE SYS - 90
CAPONORD 1200
Advertisement
