Advertisement
CAPONORD 1200
•
Straighten the safety plate (1) on the
counter-lock ring (2) and remove it
from steering yoke pin.
•
Take the suitable tool for working on
the steering ring nuts.
•
Loosen the counter-lock ring (2) and
remove it together with the rubber
spacer (3) from the steering yoke pin.
Specific tooling
020884Y 46 mm wrench for steering ring nut
Carry out the following operations:
- carry out a first tightening of the ring nut to the
indicated tightening torque for the settlement of the
steering package.
- turn the steering completely from both sides, for
several times.
Loosen the ring nut completely.
- carry out the final tightening of the ring nut to the
indicated tightening torque.
pos.
Description
1
Headstock ring nut - pre-tightening
1
Headstock ring nut - tightening
•
Install the rubber spacer (3).
•
Hand screw counter-lock ring (2) until
against spacer (3).
•
Install a new safety plate (1) and bend
it on the ring nuts.
STEERING RING NUT
Type
Qua
ntit
y
M25x1
1
M25x1
1
Torque
60 Nm (44.25 lb
Unscrew after pre-tightening
ft)
50 +/- 5 Nm
(36.88 +/- 3.69 lb
ft)
Suspensions
Notes
-
SUSP - 325
Advertisement
