Advertisement
CAPONORD 1200
cated by the diagnostics instrument: if the voltage does not vary, there is a short circuit in
the cable wiring; replace the throttle grip sensor if the voltage drops to zero.
•
if the circuit is open, shorted to negative: check the throttle grip sensor connector and the
Marelli control unit connector. If not OK, restore. If OK, check circuit continuity between the
two cable terminals. If not OK, restore; if OK, check the cable ground insulation (from the
throttle grip sensor connector or the control unit connector): if the cable is not ground insu-
lated, restore the wiring. If it is ground insulated, and with the key set to ON, check that there
is power supply for the potentiometer PIN A and that PIN C is connected to ground. If both
are correct, replace the throttle grip sensor; if not, check the continuity of the cable that is
not functioning properly: if there is continuity, replace the control unit; if not, restore the wiring
Blue front connector throttle grip position sensor - track B P0151
•
short circuit to positive / open circuit, short circuit to negative
Error cause
•
If shorted to positive: excessive voltage has been detected at PIN 13 of the ENGINE con-
nector. If the circuit is open, shorted to negative: voltage equal to zero has been detected
at PIN 13 of the ENGINE connector
Troubleshooting
•
short circuit to positive: check the value shown by the parameter of the BLUE front connector
Throttle Grip position Sensor track B: disconnect the connector and read the value indicated
by the diagnostics instrument: if the voltage does not vary, there is a short circuit in the cable
wiring; replace the throttle grip sensor if the voltage drops to zero.
•
if the circuit is open, shorted to negative: check the throttle grip sensor connector and the
Marelli control unit connector. If not OK, restore. If OK, check circuit continuity between the
two cable terminals. If not OK, restore; if OK, check the cable ground insulation (from the
throttle grip sensor connector or the control unit connector): if the cable is not ground insu-
lated, restore the wiring. If it is ground insulated, and with the switch key set to ON, check
that there is power supply for the potentiometer PIN D and that PIN F is connected to ground.
If both are correct, replace the throttle grip sensor; if not, check the continuity of the cable
that is not functioning properly: if there is continuity, replace the control unit; if not, restore
the wiring
DIAGNOSTICS INSTRUMENT: ELECTRICAL ERRORS
White rear connector throttle grip position sensor - track C P0152
•
short circuit to positive / open circuit, short circuit to negative
Error cause
Electrical system
ELE SYS - 119
Advertisement
